yeah, it'll stop when you leave listening range too :( 

this is a difficult problem in quake, in rubicon2 i tried to solve it by constantly triggering the sound when the player is within a medium range from the player, but this probably only works for white-noise type sounds since otherwise you'll hear clicking/popping i think. 

Hmm, good to know that sometimes you just have to "wing it" with these things. My current waterfall situation is working 100% as much as I know it can so I am happy about it. I think I might stick with just aesthetic falls from here on out though. Those blood waterfalls just have to be used somewhere! ;) 

Am I understanding it correctly that path_corners need to be set at regular intervals along desired path, because they are sound emitters and not train itself?

In Preach articles I saw instructions for changing path once to alternate. Any other interesting tricks/hacks with trains and path?

Don't remember exact map name from original Quake that had a lift going between 3 floors stopping for a second at each floor. Was it func_train also? In any case how does it work? 

I think each corner has a wait of "-1" so it just waits at each floor until it gets triggered again. 

Is the map you are thinking about. I think they just had a large elevator like func_train with waits set to go off. So once triggered, it would go up to the second floor and wait for 3 or so seconds then proceed to it's third path corner. Since the original Quake can't re-activate a func_train when it reaches a corner set to wait: -1, I am thinking maybe they had a fourth path corner that is in the same spot as the second floor one that targets back to the 1st floor.

I would need to play the map again or check the source to be sure though! 

Is the map you are thinking about. I think they just had a large elevator like func_train with waits set to go off. So once triggered, it would go up to the second floor and wait for 3 or so seconds then proceed to it's third path corner. Since the original Quake can't re-activate a func_train when it reaches a corner set to wait: -1, I am thinking maybe they had a fourth path corner that is in the same spot as the second floor one that targets back to the 1st floor.

I would need to play the map again or check the source to be sure though! 

i don't think this is a feature of stock quake because to do it in rub2m2 i had to change the code. 

Up/down buttons for every floor of the lift.

Should be doable in AD... 

r

I hate that lift 

Make the lift a secret. And there is an instant death pit under it. 

Make the lift a secret. And there is an instant death pit under it.

DoomII.txt: the only way to complete the level is though the secret area.

Anyway this reminds me. I have just finished Doom II, Map 19 "The Citadel", by Sandy Peterson. Overall it's a pretty fun map, but the only way to the exit requires you to go through a secret area (like what da fuq does "secret" even mean at this point?), but anyway, whatever.

This map is notable however, for containing possibly the worst level design idea I've ever seen:

At a certain point in the level, there is a little alcove containing a powerup, a Soulsphere. Now I dunno about you, but when I find a powerup tucked away in a little corner like that, and there are no monsters around, and I don't need the powerup, I don't pick it up. I make a mental note that it is there, and go on my merry way. If I need it, I can quickly rush back and grab it.

So, I proceed to spend a sanity-destroying amount of time wandering around the entire map trying to figure out how the fuck to proceed. I give up after a while and consult a walkthough on the internet.

Turns out the way forward is via that powerup I found earlier. If you go to pick the powerup up, you don't actually pick it up, instead - nonsensically - you get teleported to a new bit of the map, which is the way to progress. (And no, before you ask, it's not sitting on a visible teleporter, it's just sitting in an ordinary, plain alcove).

Yeah, defend that, Doom level design apologists. 

 

Had some terrible maps. 

 

 

When looping, please please use at least two or three. I hate falling off just to have to wait for it to go all the way around the loop. And falling into instadeath under it is not cool. Have fun DeeDoubleU.

Yes path_corners tell the train where to go, but remember that it is the location of the lower left corner of the bounding box. 

When looping, please please use at least two or three. I hate falling off just to have to wait for it to go all the way around the loop. And falling into instadeath under it is not cool. Have fun DeeDoubleU.

Yes path_corners tell the train where to go, but remember that it is the location of the lower left corner of the bounding box. 

double posting! :( 

Even if I will use an instadeath secret you would have to work your ass to get to it! 10 hidden switches and rampcirclejump at the very least.

Good idea to use two trains, will do. 

The func_door_secret is limited in that it only goes in two directions when opening. One could use the func_train to make an elaborate secret door, but it can only open once when you set the last path corner wait to -1. 

Could you use the angles key to allow for more directions? I seem to recall a Preach blog:

https://tomeofpreach.wordpress.com/2014/06/26/unusual-func_door_secret-angles/ 

Hi again,

Is there a link to acquire the most recent Quoth2.fgd file? The option I used was from Preach's Blog and while that is up to date, I don't see any mdl paths defined which causes just bounding boxes to display in the editor.

If I am expected to add the mdl paths myself I can do that but was just wondering if someone just had a quick link to the file.

Sorry if I am missing something! 

Which editor?